Packaging For Shipping Or Storage - Xantrex XPD 120-4.5 Operating Manual

Section 2. Installation
Returning Power Supplies to the Manufacturer
Packaging for
Follow these instructions to prepare the unit for shipping or storage.
Shipping or
1. When returning the unit or sending it to the service center, attach a tag to the unit
Storage
2. For storage or shipping, repack the power supply in its original container. If the
3. Label the carton as shown in
4. If shipping, mark the address of the service center and your return address on the
5. If storing, stack no more than eight cartons high. Check the storage temperature
Figure 2.1 Shipping or Storage Carton Label
26
stating its model number (available from the front panel label) and its serial
number (available from the rear panel label). Give the date of purchase and an
invoice number, if you have it, as well as a brief description of the problem.
original container is not available, seal the unit in a plastic bag and then pack it
in a 200 lb. (90 kg) test, corrugated cardboard carton large enough to allow 2
inches (5 cm) of cushioning material to surround the unit. Use a material such as
foam slabs or chips.
carton.
range and storage altitude specification in
page 21.
POWER SUPPLY
Model Number: _______________________
Serial Number: _______________________
FRAGILE — ELECTRONIC EQUIPMENT
Figure 2.1.
"Environmental Specifications" on
Operating Manual for XPD Series Power Supply