Parallel Communication Card - Delta Modulon DPH Series User Manual

No.
1 None
2 Generator Status
3 Battery Ground Fail
External Battery Breaker
4
Detection
5
6
7 Battery Abnormal Shutdown
8 Input Transformer OTW
9 Output Transformer OTW
10 Battery Fuse Open
NOTE:
*
and Charger Off (Negative) these two items. Please refer to 7.10.4 Battery &
Charging Setting and 7.10.6 Dry Contact Setting to perform relevant setup. If
you have any questions, please contact Delta customer service.

4.1.7 Parallel Communication Card

The UPS has one parallel communication card and the card includes two parallel ports and
one LED indicator. Please see Figure 4-11 for relevant location. If the card works normally,
its LED indicator will illuminate green; if not, the LED indicator will illuminate red. During
DISPLAY
EXT. BATT
TEMP.
BT1 BT2
REPO
NC NO
BT3 BT4
(Figure 4-11: Location of Parallel Communication Card and its LED Indicator)
Modulon DPH Series
Event
1
If you use non-Delta lithium-ion batteries, you must set up
O/P DRY I/P DRY
EXT.SWITCH
STATUS CONTACT CONTACT
S1 S2 P1 P2 P3 P1 P2
S3 S4 P4 P5 P6 P3 P4
Parallel Communication
Card's LED Indicator
No set-up.
Generator status detection.
Battery leakage detection.
Status detection of the external battery cabinet'
breaker or switch.
1
*
1
*
In On-Line mode: the UPS will issue battery
abnormal warning.
In Battery mode: the UPS will turn to Bypass or
Standby mode immediately.
Input transformer over temperature warning.
Output transformer over temperature warning.
The battery fuse is blown.
PARALLEL
Parallel
Communication Card
4-10
Description
USB RS-232
BATT.
START
BATT.
START