Introduction; Attention; Instructions Of Safety - Teltonika FM1200 User Manual

1 INTRODUCTION

1.1 Attention

1.2 Instructions of safety

This chapter contains information on how to operate FM1200 safely. By following
these requirements and recommendations, you will avoid dangerous situations. You must
read these instructions carefully and follow them strictly before operating the device!
The device uses a 10 V...30 V DC power supply. The nominal voltage is 12 V DC.
The allowed range of voltage is 10 V...30 V DC.
To avoid mechanical damage, it is advised to transport the FM1200 device in an
impact-proof package. Before usage, the device should be placed so that its LED
indicators are visible, which show the status of operation the device is in.
When installing the connection cables to the vehicle, the appropriate jumpers of the
power supply of the vehicle should be disconnected.
Before dismounting the device from the vehicle, the connection cables must be
disconnected.
Do not disassemble the device. If the device is
damaged, the power supply cables are not isolated
or the isolation is damaged, before unplugging the
power supply, do not touch the device.
All wireless data transferring devices produce
interference that may affect other devices which
are placed nearby.
The device must be connected only by qualified
personnel.
The device must be firmly fastened in the
predefined location.
The programming must be performed using a
second class PC (with autonomic power supply).
The device is susceptible to water and humidity in
environment with IP class greater than IP67.
Any installation and/or handling during a lightning
storm are prohibited.
FM1200 has USB interface;
Please use cables provided with FM1200 device.
Teltonika is not responsible for any harm caused
by using wrong cables for PC <-> FM1200
connection.
6