Description Of Print Settings Of Easyone Air; About Performing A Firmware Update With Easyone Air - NDD EasyOne Air Operator's Manual

Configuration
10.1.1.4.

Description of print settings of EasyOne Air

10.1.2.

About performing a firmware update with EasyOne Air

Operator's Manual V03 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch
> >
You can determine basic settings for printouts when using EasyOne Air and
the cradle. There are more comprehensive configuration options available for
printouts when using EasyOne Connect.
Setting
Printer
Printer page format
Data
Curve
Custom header
 Description of print settings
 Best trial/best value selection  7 3
About compatible printers  1 9
Setting up the physical components  2 0
To perform a firmware update, refer to the Application Note Updating the
Software on EasyOne Air on the ndd website.
CAUTION
FAILED UPDATE
An update may fail unnoticed.
After performing an update, restart EasyOne Air and EasyOne Connect and per-
form a calibration check.
Cybersecurity  3 7
Checking for correct operation of EasyOne Air  8 6
 Application Notes for further information  3
www.ndd.ch
For the USA: www.nddmed.com
Purpose
To select a physical printer or a virtual PDF
printer (saves a PDF file)
To select the page format in imperial or metric
dimensions
To set whether one or three trials are included
on the printout, corresponding to the best
trial/best value selection in the spirometry
settings
To set which curves are included on the
printout, corresponding to the Data setting
above
To specify four lines of text on the printout, for
customizing the printout for your institution
9000007/03
83
78/105