NDD EasyOne Air Operator's Manual page 51

Performing spirometry
Operator's Manual V03 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch
 To end the test
1 To remove the EasyOne FlowTube, do the following:
a) Grip EasyOne Air with both hands, with the backside of EasyOne Air
facing towards you and with the EasyOne FlowTube pointing up.
b) Press against the protruding lip of the EasyOne FlowTube with both
thumbs and push the EasyOne FlowTube out.
c) Do not touch the EasyOne FlowTube anywhere else than at the
protruding lip.
d) Drop the EasyOne FlowTube directly into a waste container.
2 WARNING! Patient cross-contamination and infection of the technician:
Always wear disposable gloves. Between patients, always exchange
disposable gloves, clean EasyOne Air, and disinfect hands. / Electric
shock, failure of EasyOne Air, and false diagnosis: Make sure that no fluid
penetrates the EasyOne FlowTube holder or the inside of EasyOne Air while
cleaning. To clean EasyOne Air, do not fully dip EasyOne Air into any fluid.
To clean EasyOne Air and to disinfect your hands after each patient, do the
following:
a) Use a soft cloth with a cleaning solution according to the list of cleaning
solutions under Hygiene and cleaning  6 2
the display of EasyOne Air.
b) Put down EasyOne Air.
c) Take off or change the disposable gloves and disinfect your hands
before you put on new disposable gloves.
3 If you want to print the report immediately, choose Print.
 A progress bar is displayed that indicates the progress of the print-out.
and wipe the handles and
9000007/03
51/105
57