NDD EasyOne Air Operator's Manual page 85

Calibration check
Operator's Manual V03 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch
4 Insert the EasyOne FlowTube into EasyOne Air.
 The shape of the EasyOne FlowTube and the EasyOne FlowTube holder
guide the orientation of the EasyOne FlowTube. You can only insert the
EasyOne FlowTube fully if it is positioned correctly.
5 Attach the EasyOne FlowTube cal check adapter to the calibration syringe.
 To avoid any temperature differences, fixate the syringe with two
fingers at the one end of the syringe only.
6 Attach the nozzle of the EasyOne FlowTube cal check adapter to the
EasyOne FlowTube and make sure that the piston is fully inserted.
The EasyOne FlowTube snaps into the nozzle of the EasyOne FlowTube cal
check adapter.
7 Choose > > Single
message that is displayed.
8 Wait for the baseline to be set.
9 Pull the piston all the way out as slow or as fast as required by the flow level
that is displayed.
10 Push the piston all the way in again with the same speed.
11 To end the maneuver, pull the piston briefly again.
 If the maneuver was not acceptable, you need to repeat steps 9 to 11.
 If you have chosen
acceptable, the calibration check is completed.
 If you have chosen
acceptable, proceed with step 12.
12 If you have chosen Multi flow
maneuver was acceptable, perform the next maneuvers according to the
messages that are displayed.
 If a maneuver was not acceptable, you need to repeat steps 9 to 11.
 If all maneuvers were acceptable, the calibration check is completed.
 List of troubleshooting solutions  8 6
Contact information  4
flow, Multi flow, or
Single flow before and the maneuver was
Multi flow or Linearity before and the maneuver was
or Linearity before and the previous
Linearity and confirm the
9000007/03
85/105
85