Table of Contents
Advertisement
Performing spirometry
6.3.
About quality messages for trials and quality grades for tests
6.4.
About posts and bronchodilation
Operator's Manual V03 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch
Animation program for children
If you use EasyOne Connect in combination with EasyOne Air, an animation
program for children is available. The animation is available for the FVC test,
the FVL test and the SVC test. You can choose between three animations:
balloon, cake, and monkey.
When the animation program is activated, the manufacturer recommends
disabling the manual test stop and working with the automatic test stop. You
can configure manual or automatic test stop under
> Test > General > Test
Procedure.
Breathing maneuvers for all available tests 5 8
Avoiding contamination while performing spirometry 6 2
Quality messages
To obtain reliable results, an acceptable quality of the trials is necessary. The
quality of a trial depends on cooperation of the patient and this, in turn,
depends on the quality of your instructions. To facilitate giving good
instructions to the patient, an automatic quality control function displays
feedback prompts. After each trial, a message on the screen informs you
whether the trial is acceptable or not. If the trial is not acceptable, the
message will guide you on how to coach the patient to do better.
When you see the
Test complete
trials.
Quality grades
A quality grading from A to F is displayed at the end of the test. It provides
information on the overall quality of the test. You should keep performing
trials with the patient until the quality grade is an A or a B. Only after several
trials, when the patient is exhausted and if the patient has already had a
break, a quality grade C is sufficient.
List of quality messages and quality grades 5 5
A test and a post are performed together to determine the response to
bronchodilating asthma medication.
After performing an FVC test or an FVL test, the patient is treated with a
bronchodilator. Approximately 10 to 20 minutes after the medication, when
the bronchodilator shows effect, the test is repeated as a post. The results of
the previous test and the post are then compared on the result screen and on
the test protocol. Posts can only be added to an existing test within 24 hours.
Utilities > Configuration
message, you do not need to conduct further
9000007/03
57
43/105
Hide quick links:
Advertisement
Table of Contents
