Performing Spirometry Using Easyone Air Stand-Alone; Choosing A Test And Adding A New Patient - NDD EasyOne Air Operator's Manual

Performing spirometry
6.5.

Performing spirometry using EasyOne Air stand-alone

6.5.1.

Choosing a test and adding a new patient

Operator's Manual V03 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch
If you wish to register the patient to be tested immediately before conducting
the test, you can start by manually adding a new patient.
1 If you want to perform an FVC test, choose
 The patient selection list is displayed.
2 If you want to perform any other test, do the following:
a) Choose .
?
b) Choose one of the test icons.
3 Select <Add Patient>.
 A dialog is displayed.
 The dialog consists of several steps.
4 CAUTION! False diagnosis: The predicted values and the system
interpretation are based on the patient demographic data. Therefore,
wrong patient data can cause false results. Enter patient data
meticulously. Double-check that you have entered the patient data
correctly.
In each step, enter the requested data and choose
5 In the last step, choose Finish.
6 Optionally, enter additional information about the patient.
 Performing a complete test using EasyOne Air stand-alone  4 6
.
Next >.
9000007/03
44/105
57