Table of Contents
Advertisement
Performing spirometry
7.4
About posts and bronchodilation
7.5
Performing spirometry using EasyOne Air stand-alone
7.5.1
Choosing a test and adding a new patient
Operator's Manual V1.1 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch
A test and a post are performed together to determine the response to
bronchodilating asthma medication.
After performing an FVC test or an FVL test, the patient is treated with a
bronchodilator. Approximately 10 to 20 minutes after the medication, when
the bronchodilator shows effect, the test is repeated as a post. The results of
the previous test and the post are then compared on the result screen and on
the test protocol. Posts can only be added to an existing test within 24 hours.
If you wish to register the patient to be tested immediately before conducting
the test, you can start by manually adding a new patient.
1 If you want to perform an FVC test, choose
The patient selection list is displayed.
2 If you want to perform any other test, do the following:
a) Choose
.
?
b) Choose one of the test icons.
3 Select
<Add
Patient>.
A dialog is displayed.
The dialog consists of several steps.
4 CAUTION! False diagnosis: The predicted values and the system
interpretation are based on the patient demographic data. Therefore,
wrong patient data can cause false results. Enter patient data
meticulously. Double-check that you have entered the patient data
correctly.
In each step, enter the requested data and choose
5 In the last step, choose Finish.
The summary screen is displayed.
About the summary screen, 56
Performing a complete test using EasyOne Air stand-alone, 57
.
Next
>.
54/144
74
Advertisement
Table of Contents
