NEC Aspire S Manual page 202

Section 5: Data and SMDR
➻
35-02-18 : SMDR Output Options - Caller ID Name Output Method
Select whether to display up to 16 characters of the Caller ID Name on the same line as the call record
(0) or if a line feed should be added and up to 24 characters of the Caller ID Name will be displayed on
the following line (1). If the line feed option is selected, the Caller ID Name will be displayed on the
next line as : NEXT "Caller ID Name". The default entry for this option is "0".
This setting will work regardless of the setting in Program 35-02-15.
Note: With this option set to "1", if your communications program (such as HyperTerminal) has the
line wrap option enabled in the ASCII setup, an additional line break may appear above the Caller ID
name line.
➻
35-03-01 : SMDR Port Assignment for Trunks
For each trunk group, select the SMDR port to which the incoming information should be sent.
➻
35-04-01 : SMDR Port Assignment for Department Groups
Assign the SMDR port for each Department Group. For each Department Group, select the SMDR port
to which the outgoing SMDR information should be sent.
➻
80-05-01 : Date Format for SMDR and System Reports
Set the date format for SMDR (0=American, 1=Japanese or 2=European).
Refer to Station Message Detail Recording in the Software Manual for additional details.
5-8 ◆ Section 5: Data and SMDR
Aspire S Hardware Manual