NEC Aspire S Manual page 173

Wall Installation
Standard Wall Plate Mounting
This phone is designed to be mounted on a standard wall plate. To attach the wall mount stand to the Base
Unit:
1. Slide the Wall Mount stand into the notches at the top of the Base Unit, push the Wall Mount stand
down and snap it into place.
2. Plug the AC Adapter into the Base Unit.
3. Place the AC Adapter cord inside the molded channel of the Wall Mount stand.
4. Plug one end of the short telephone cord into the LINE jack on the Base Unit. Optionally, plug one
end of an NEC keyset desk phone into the phone jack. Then place the telephone cord(s) inside the
molded channel(s) on the bottom of the Wall Mount stand
5. Plug the other end of the short telephone cord into the modular wall jack.
6. Place the Base Unit on the posts of the wall plate and push down until it's firmly seated.
7. Plug the AC Adapter into a standard 120V AC wall outlet.
Figure 4-62: ATTACHING THE WALL MOUNT PLATE
Direct Wall Mounting
If you do not have a standard wall plate, you can mount your phone directly on a wall.
Before mounting your phone, consider the following:
● Select a location away from electrical cables, pipes, or other items behind the
mounting location that could cause a hazard when inserting screws into the wall.
● Make sure the wall material is capable of supporting the weight of the Base Unit.
●
Use #10 screws with anchoring devices suitable for the wall material where the
Base Unit will be placed.
1. Insert two mounting screws into the wall 3-15/16 inches apart. Allow about
3/16 of an inch between the wall and screw heads for mounting the phone.
2. Plug and secure the AC Adapter cord by following steps 2 and 3 of the Standard
Wall Plate Mounting.
Aspire S Hardware Manual
Section 4: Telephones and Optional Equipment
Note: Do not use an outlet controlled by a wall switch.
Section 4: Telephones and Optional Equipment ◆ 4-67
Figure 4-63: ATTACHING TO THE WALL PLATE
Figure 4-64: POSITIONING
4
THE SCREWS