Removing The Adapter Cover (Figure 4-22) - NEC Aspire S Manual

Section 4: Telephones and Optional Equipment
1 = The IP Adapter takes the full space provided for adapters on the keysets. Therefore, if an IP adapter is
installed, no other adapters can be used.
2 = Only one adapter of the same type can be used on a keyset.
3 = As there is only one voice path provided for adapters, the APR and APA adapters can not both be used
on the same keyset.
4 = Due to protocol collision, the CTU and CTA adapters can not both be used on the same keyset.
5 = The ADA2 and PSA Adapters can only be installed on the Aspire IPhone, which only has one adapter
connection. Therefore, if either the ADA2 or PSA is installed, no other adapters can be used.
6 = As this adapter requires the AC power adapter, it can not be installed on a phone with an APR or
Speakerphone adapter, which also requires power. The placement of the AC power adapter plug will
not allow the unit installed on the left side of the phone to receive power.
When installing or removing the adapters, the keyset should first be unplugged from the system. Also note
that the adapters may have an AC/DC power jack. Power is not required for all the adapters. You should refer
to the information for the specific adapter to determine whether a power source is needed.
Telephones with any of these adapters installed cannot be wall-mounted. The bracket will not accommodate
the adapter(s).

Removing the Adapter Cover (Figure 4-22)

1.
2.
3.
4-30 ◆ Section 4: Telephones and Optional Equipment
With certain applications, it may be necessary to remove the cover from an adapter. First, remove
the screw on the back of the adapter.
Using a small screwdriver, push in the ribs on the sides of the adapter.
Do not push the ribs in too much or they may break.
Remove the cover.
Up
Rib
Screw
Figure 4-22: REMOVE THE ADAPTER COVER
Adapter Compatibility Chart
Body of the cover
Rib
Small screwdriver
Aspire S Hardware Manual