Setting Up Extension Circuit Types - NEC Aspire S Manual

Setting Up Extension Circuit Types

Run Program 10-03 to set up extension circuit types as required. The system will automatically detect and
assign most circuit types when the device is connected. Refer to the Software Manual for programming
information.
1. Dial 10-03-01.
2. Select the slot, port or channel (with ESIU-S PCBs) to be programmed by pressing FLASH.
3. Set the terminal type or option as needed.
As the system recognizes the extension devices automatically, when replacing the type of device connected,
the type must be undefined in Program 10-03 prior to connecting the new device. For example, if a port was
previously used for a keyset and a DSS Console is to be installed in that same port, it must first be undefined
in Program 10-03 before the console is connected.
Aspire S Hardware Manual
Section 2: PCB Installation and Startup
Alphanumeric
Display
SERVICE
RINGING
MENU 1
CHECK
1 2 3
7 8 9
13 14 15
19 20 21
MSG
1
FLASH
4
CONF
7
Page and BGM
Volume Control
Figure 2-17: TELEPHONE KEY LAYOUT
Refer to the Software Manual for this information.
If the system has DSS Consoles, Program 30-02 must be used to define DSS extension assignments.
Soft Keys
guide you through your
features. While your phone is
idle, the Soft Keys are normal
One Touch Keys.
Message Waiting
Lamp
MENU 2
CLEAR
4 5 6
10 11 12
Programmable
16 17 18
Function Keys
22 23 24
Abbreviated
Dialing
DIAL CALL 1
2 3
Dual Line
LND CALL 2
5 6 Appearance Keys
MIC DND
Last Number
8 9
Redial
SPK HOLD
0
Do Not Disturb
VOL
Microphone Cutoff
Speakerphone
Handsfree,
Microphone
Handset,
Section 2: PCB Installation and Startup ◆ 2-43
2