NEC Aspire S Manual page 139

4. If using the mono audio jack to connect to the recorder or audio input, plug the audio jack into the
REC connector on the ADA and then skip to Step 9. If wiring directly to the terminals inside the
adapter, remove the screw on the back of the adapter. Using a small screwdriver, push the ribs on
the sides of the adapter in and remove the cover.
5. Determine which terminals should be connected. Terminals T3 and T4 are used for wiring to a
recorder.
ore received. The dip switch "1" must be set to the "on" position.
6. Run the cable to the ADA adapter through the opening near the audio jac.
7. Insert the cable into the terminal. Place the cap over the terminal and push down to secure the cable.
Aspire S Hardware Manual
Section 4: Telephones and Optional Equipment
Do not push the ribs in too much or they may break.
Remove screw
Figure 4-25: REMOVE THE SCREW FROM THE ADA ADAPTER
T6 and T7 are used to activate a relay. T his relay will turn on a recorder when a call is placed
Figure 4-26: RUNNING THE CABLE TO THE ADA
Cap
Cable
Figure 4-27: WIRING TO THE ADA TERMINAL
Section 4: Telephones and Optional Equipment ◆ 4-33
ADA Module
4