NEC Aspire S Manual page 181

Connecting the IPhone
1. Set the dip switches on the bottom of the Aspire IPhone to the required position. The setting is
dependent upon the type of power supply being used.
●
2. Plug an AC/DC adapter into the AC jack on the adapter if power is not supplied by the LAN.
3. Plug in the LAN straight-thru cable from the 4VOIPU-S PCB LAN connector for the phone opera-
tion. If needed, connect the PC cross cable to the VoIP Adapter.
4. Refer to Section 6: LAN Connection (page 6-1) for additional LAN and PoE information.
5. Refer to the Aspire Software Manual (P/N 0893200) for required programming.
PC Connection
Straight-Thru
Ethernet PC
Aspire S Hardware Manual
Section 4: Telephones and Optional Equipment
The SW1 settings are:
"1" when using an AC/DC adapter or NEC Power Patch Panel (SN1604 PWRMS) or NEC PoE
Switching hub (BF200/24PoE),
"2' when using Cisco's Power Patch Panel or Catalyst PWR panel.
Figure 4-74: SETTING THE ASPIRE IPHONE DIP SWITCHES
Aspire IPhone,
Aspire Keyset with IP Adapter or
H.323 Terminal
Cable
Figure 4-75: WIRING LAYOUT FOR VOIP
Ethernet
Straight-Thru
Cable
LAN
AC Adaptor
(Not needed if power
supplied by LAN)
Section 4: Telephones and Optional Equipment ◆ 4-75
Aspire Cabinet
CPU
4VOIPU
4VOIPDB
ENTU
4