Removing An Extension Or Trunk Pcb; To Remove An Extension/Trunk Pcb; Uninstalling A Pcb Slot Through Software - NEC Aspire S Manual

Section 2: PCB Installation and Startup

Removing an Extension or Trunk PCB

Whenever powering down the system, check to make sure the only LED flashing on the CPU card itself is the
LD2 LED (farthest right). This LED is located in the lower left-hand corner of the CPU. If any other LEDS
are flashing on the CPU, wait until they stop or else the system data may be corrupted.

To remove an extension/trunk PCB:

● Turn off the system power by pressing the ON/OFF switch on the cabinet.
● All PCBs must be installed with the system power off.

Uninstalling a PCB Slot Through Software

The installer can turn off (busy out) and delete (remove from software) PCB slots in the cabinet in program-
ming for port re-numbering purposes or to replace it with a different type of PCB. Deleting a PCB may
affect PCB slot programming capability. Refer to Program 90-05 in the Software Manual for further details.
2-4 ◆ Section 2: PCB Installation and Startup
Whenever powering down the system, check to make sure the only LED flashing on the CPU
card itself is the LD2 LED (farthest right of the LEDs). This LED is located in the lower left-hand
corner of the CPU. If any other LEDS are flashing on the CPU, wait until they stop or else the sys-
tem data may be corrupted.
Aspire S Hardware Manual