Required Accessories; S-Bus Connection - Bosch Rexroth IndraControl S67 Application Description

32/61 Bosch Rexroth AG
Connecting Data and Supply Cable
6.2

Required Accessories

6.3

S-BUS Connection

Rexroth IndraControl S67 Digital Module High Speed 8 Outputs – 0.1 A (4×M12)
The Bosch Rexroth accessory components listed below are required for con‐
necting the data and supply cable. The corresponding order numbers are lis‐
ted in chapter 12 "Accessories" on page
● S-BUS M12 terminator, IP 67 degree of protection
● S-BUS and supply cables, ready-made on both ends, IP 67
● Protective caps
The S-BUS is used for communication between a field bus coupler and the
connected IndraControl S67 components.
Requirement
● A Bosch Rexroth S-BUS cable ready-made on both ends is available,
which is necessary for optimal signal transmission.
● The S-BUS terminator is available, which is necessary for communica‐
tion.
The following table outlines the assignment of the S-BUS connections:
Connection
OUT
IN
4
4
1 5 3 3 5
2
2
Tab. 6-1: S-BUS: Pin assignment
To connect the S-BUS cable to the field bus coupler and to the modules, pro‐
ceed as follows:
1. Disconnect the power supply from those devices on which you have
mounted the S67-DO8-HS-M12 module.
2. Connect the S-BUS cable (S1) to the OUT connection
bus coupler and the IN connection
ule. For example, if two modules have been connected to the field bus
coupler, connect the S-BUS cables (S1, S2) to the associated IN and
OUT connections, as shown in the figure below.
3. Tighten the plugs and sockets using the knurled-head screw.
4. Attach the S-BUS terminator (T) to the last module as shown in the fig‐
ure and tighten the S-BUS terminator.
DOK-CONTRL-S67DO8M12HS-AP02-EN-P
51.
Contact Description
IN
1 RD+
2 RD-
3 TD-
1
4 TD+
5 0 V DC
Connection Shielded
thread
(1) of the S67-DO8-HS-M12 mod‐
OUT
TD+
TD-
RD-
RD+
(3) of the field