Removing The Field Bus Coupler From The Profile Adapter; Connecting The Module; Disposal - Bosch Rexroth IndraControl S67 Application Description

50/61 Bosch Rexroth AG
Maintenance and Service
11.2.5

Removing the Field Bus Coupler from the Profile Adapter

11.2.6

Connecting the Module

11.3

Disposal

Rexroth IndraControl S67 Digital Module High Speed 8 Outputs – 0.1 A (4×M12)
A
Fig. 11-1: Removing the module with mounting rail adapter from the
mounting rail
If the S67-DO8-HS-M12 module is mounted on a profile adapter, proceed
with the removal as follows:
1. Disconnect the power supply from the device on which you have moun‐
ted the S67-DO8-HS-M12 module before beginning to remove the mod‐
ule.
2. Unscrew the screws on which the nuts are fastened and remove the
S67-DO8-HS-M12 module from the profile rail of the system.
3. Unscrew the screws that connect the S67-DO8-HS-M12 module with
the profile adapter.
To connect the new S67-DO8-HS-M12 module proceed as described in the
following chapters:
● chapter 5 "Mounting the Module" on page 23
● chapter 6 "Connecting Data and Supply Cable" on page 31
● chapter 7 "Commissioning" on page 37
If necessary, the parameters of the previous S67-DO8-HS-M12 module are
transferred to the new module, depending on the type of the field bus coupler
being used (see also chapter 9.5 "Automatic Storage of System Parameters"
on page 43).
Do not dispose of the IndraControl S67 components in the household waste;
observe the local applicable laws. You can also contact a certified disposal
company.
DOK-CONTRL-S67DO8M12HS-AP02-EN-P
B C