Prior To Assembly; Required Tools; Required Accessories - Bosch Rexroth 4WS2EM 10 Series Operating Instructions Manual

7.4 Prior to assembly

Explosion hazard due to wrong area of application!
A valve which is not approved for the area of application may cause an explosion!
▶ Check whether the explosion protection marks on the name plate of the valve
comply with the information in these operating instructions.
▶ Please check if you have the right valve type by means of the type designation on
the name plate of the valve.
▶ Check whether the zone assignment and the temperature class correspond to
the area of application of the valve.
▶ Check the scope of delivery for completeness and possible transport damage.
▶ Also observe the safety instructions in chapter 2.6 "Product-specific safety
instructions".

7.5 Required tools

You only require standard tools to assemble the valve.

7.6 Required accessories

The following accessories are recommended for the connection of the valve.
These accessories can be ordered separately from Bosch Rexroth:
Subplates
Subplates with dimensions for valves with porting pattern according to
ISO 4401 are listed in the "Data sheet 45100".
Flushing plate
Table 10: Flushing plate
HSA 10 B019-4X/V00-J3
Test device
Explosion hazard!
The test device is not approved according to the EU Explosion Protection
Directive 2014/34/EU. The use of the test device in an explosive atmosphere may
cause an explosion!
▶ Only use the test device if the occurrence of an explosive atmosphere during the
test can be excluded with certainty.
Table 11: Test device
Test device VT-SVTSY, battery-operated, can optionally be
operated with power supply unit
WARNING
Material number
R901541299
WARNING
RE29583-XL-B/09.20, 4WS2EM 10...XL..., Bosch Rexroth AG
Installation 25/48
Documentation to be carried
Data sheet 29681