Parameterization; General Information; Diagnostic Overview - Bosch Rexroth IndraControl S67 Application Description

DOK-CONTRL-S67DO8M12HS-AP02-EN-P
Rexroth IndraControl S67 Digital Module High Speed 8 Outputs – 0.1 A (4×M12)
9

Parameterization

9.1

General Information

9.2

Diagnostic Overview

According to the field bus type only certain parameters are available for pa‐
rameterization. Further information can be found in the respecting documen‐
tation of the field bus coupler.
WARNING
When parameters are changed incorrectly, machine components can be
placed in a dangerous state and endanger persons and machines. Before
changing the parameters, ensure that the machine components are in a safe
and defined state and switch off the higher-level controller. Ensure before
start-up that no persons remain in the danger area of the machine compo‐
nents.
For parameterization with IndraWorks, set the operating settings of the S67-
DO8-HS-M12 module, e.g. the behavior in the event of failures, the release of
diagnostic messages etc.
The operating settings are transmitted via parameter telegram to the S67-
DO8-HS-M12 module operated at the S-BUS.
The parameters of the S67-DO8-HS-M12 module are set in IndraWorks. By
double-clicking the S67-DO8-HS-M12 module in the project explorer, the pa‐
rameterization user interface is opened in the workspace. The S67-DO8-HS-
M12 module is parameterized offline. The offline mode enables the parame‐
terization of an S67-DO8-HS-M12 module that is not yet present. Firstly, the
set parameters are saved in the project. The parameter data is transmitted
during the download of the PLC program.
The S67-DO8-HS-M12 module supports module-comprehensive and chan‐
nel-specific diagnostics. The transmission of diagnostics can be activated
and deactivated. If diagnostics is deactivated, the display behavior of the
LED(s), which signalize(s) the respective diagnostics, changes. For further in‐
formation please refer to
45.
Diagnostic messages of the S67-DO8-HS-M12 module are specified accord‐
ing to the following tables:
Bosch Rexroth AG
Changing parameters!
chapter 10 "Diagnostics via LED Signals" on page
41/61
Parameterization