DOK-CONTRL-S67DO8M12HS-AP02-EN-P
Rexroth IndraControl S67 Digital Module High Speed 8 Outputs – 0.1 A (4×M12)
Purpose
1.4
Structuring the Documentation
Mounting
Product
Selection
phases
(assembly/installation)
Presales Aftersales
Design engineer
Mechanic/
electrician
Programmer
Technologist
Target
Process
groups
specialist
Select
Prepare
Activities
Design
Construct
Fig. 1-1:
Assigning this documentation to the target groups, product phases
and target group activities
This documentation is intended for users commissioning a digital output mod‐
ule of type S67-DO8-HS-M12. This documentation contains general informa‐
tion on the output module. Mounting and cabling of the output module are al‐
so described. The basic commissioning steps and the configuration of the
IndraControl S67 station are then explained.
The first part of the documentation contains important information on the in‐
tended use as well as information on the safety instructions
portant Instructions on Use" on page 9
Instructions" on page
11).
For a short overview on the structure and the functions of the digital output
module, refer to
chapter 4 "Device Description" on page
For information on mounting, refer to
page
23.
For information on data and supply cables, refer to
Data and Supply Cable" on page
For information on the commissioning, refer to
on page
37.
For information on the process images of the digital output module, refer to
chapter 8 "Process Images" on page
For the parameterization, refer to
For the diagnostic options regarding the digital output module, refer to
ter 10 "Diagnostics via LED Signals" on page
For information on the module exchange, refer to
and Service" on page
49.
For information on the accessories for the digital output module, refer to
chapter 12 "Accessories" on page
For diagnostic information, refer to
For information on the customer service help desk of Bosch Rexroth, refer to
chapter 14 "Service and support" on page
Bosch Rexroth AG
Engineering
Commissioning
Programmer
Commissioning engineer
Technologist
Process specialist
Unpack
Parameterize
Optimize
Mount
Program
Test
Install
Configure
Simulate
and
chapter 3 "Using the Safety
chapter 5 "Mounting the Module" on
31.
chapter 7 "Commissioning"
39.
chapter 9 "Parameterization" on page
45.
51.
chapter 13 "Appendix" on page
57.
7/61
About this Documentation
Operation
Decommissioning
Machine
operator
Maintenance
Mechanic/
technician
electrician
Service
Disposal company
Operate
Dismount
Maintain
Dispose
Remove
faults
Create
the NC program
(chapter 2 "Im‐
13.
chapter 6 "Connecting
41.
chap‐
chapter 11 "Maintenance
55.