Table of Contents
Advertisement
26/48
Assembly
Valve mounting screws
Subplates
Ordering address for
accessories and valves
Bosch Rexroth AG, DBET.../...XE, RE29162-XE-B/10.20
7.6 Required accessories
The following accessories are recommended for the connection of the valve.
These accessories are not included in the scope of delivery and can be ordered
separately from Bosch Rexroth:
For reasons of stability only use the valve mounting screws listed in
"Data sheet 29162-XE".
For subplates with dimensions for valves with porting pattern according to
ISO 4401, refer to "Data sheet 45100".
The address of our responsible sales organizations can be found on the Intranet at
www.boschrexroth.com
and in the appendix 16.1 "List of addresses".
7.7 Assembling the valve
7.7.1 Installing the valve in the system
Faulty installation of plug screws and lines!
Improperly fastened plug screws and lines may become loose during subsequent
operation and be ejected due to the pressure. This may cause serious injuries!
▶
Only pressurize your system after all plug screws and lines have been completely
and properly mounted according to the specification.
Faulty mounting!
Mounting of the valve with valve mounting screws of reduced stability, insufficient
mounting or fastening at blocks and plates with insufficient stability may lead to
the valve becoming loose and falling down. Consequently, hydraulic fluid may leak
and lead to personal injuries and/or damage to property. Particular caution applies
to valves with suspended installation.
▶
Completely assemble the valve according to the assembly specifications by
means of suitable assembly aids.
▶
Only assemble the valve at blocks or plates suitable for the weight of the valve.
▶
Observe the tightening torques, screw stability and the minimum length of the
valve mounting screws.
WARNING
Advertisement
Table of Contents
