2.4.6 Adjusting the legrests
The legrests are single part units and may be used as leg supports or, after
readjusting, as feet support (footrests).
setting as leg rests
Fastening legrests to the bed:
Holders of the legrests are inserted into square openings on the side of the seat
and they are locked by tightening the security screw on the bottom side of the
seat. The legrest may be removed from the AVE birthing bed by loosening the
security screws and removing, by pulling out, of the leg rests from the seat.
Setting of new leg rests is very simple, it is fast, safe and could be done using
two securing levers at each of the leg rests.
After releasing the upper securing lever the upper tray of the rests may be
secured as follows:
Footrest vertical positioning angle
Footrest horizontal positioning angle
BORCAD Medical a.s.
739 45 Fryčovice 673, tel.: +420 558 640 611, fax: +420 558 668 087
setting as footrests
-90°/+45°
-16°/+48°
Locked
Loose
33
www.borcadmedical.com