BORCAD Medical AVE PPA-AX30 Instruction Manual page 27

How to erase saved position
If all five positions have been saved but some new controller should be
assigned, all the controllers connected so far must be deleted from the receiver
memory. To delete them, please hold the matching button (use a non-
conducting object for this purpose) on AVE bed receiver and AVE wireless foot
control for the period of 5 seconds. Then wait another 5 seconds before you
start to match a new foot controller.
Error Messages
Error messages are indicated by means of a LED located on the mobile foot
controller. When operating the device, the following situations can occur:
A remote control button is
Almost discharged battery
Communication lost
Control of the wireless
controller at the chair back
board is turned off
Remote control does not work if the birthing bed is not connected to the
power network. It is recommended to replace the batteries every two
years!
BORCAD Medical a.s.
739 45 Fryčovice 673, tel.: +420 558 640 611, fax: +420 558 668 087
stuck
When a button is turned on for more
than 60 s, indication of the button
permanently turned on is activated
through LED flashing. This indication
lasts 30 minutes from error identification
or it can be turned off by pressing any
other button. The other buttons continue
to be functional
LED flashing for 15 s after a button has
been pressed (orange color)
LED flashing for 15 s after a button has
been pressed (orange color)
LED flashing for 15 s after a button has
been pressed (orange color)
27
www.borcadmedical.com