Motor Setting (Wireless Foot Controller) - BORCAD Medical AVE PPA-AX30 Instruction Manual

2.4.3 Motor setting (Wireless foot controller)

The wireless foot controller ensures a remote radio transmission of signals for
activating movement functions of the AVE birthing bed. The remote control
transmitter is supplied by two ALKALINE batteries type LR14, size C, voltage
1,5 V, supposed minimum operating life is about half a year. Wireless foot
controller signal range is 5 m from the transmitter located in the bed base.
Equipment control:
For proper execution of chair movement, pressing (clutching down) and holding
corresponding button of the foot controller is necessary.
This controller is also equipped with a protective wire, which can be held to
carry the controller.
Signaling LED
diode
Tilt seat section
Height
adjustment of
laying section
Matching the remote controllers and AVE
 Maximum of 5 foot controls, which can work together then, can be
paired with one bed (receiver in the bed base has 5 positions, into
which individual foot controls are stored)
 If the remote control is coupled with the bed for the second time and it
was already coupled with this bed before, then the remote control is
coupled for a new position (unless the reset occurred).
BORCAD Medical a.s.
739 45 Fryčovice 673, tel.: +420 558 640 611, fax: +420 558 668 087
Tilt of back
section
25
www.borcadmedical.com