Adjusting The Vertical Headlight Beam - APRILIA RS 50 TUONO Use And Maintenance Book

ADJUSTING THE VERTICAL
HEADLIGHT BEAM
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
use and maintenance RS 50 Tuono
66
1
To adjust the headlight beam:
Unscrew and remove the three screws
◆
(1) securing inner cover (2).
Remove front fairing inner cover (2).
◆
CAUTION
H a n d l e t h e p l a s t i c a n d p a i n t e d
c o m p o n e n t s w i t h c a r e a n d a v o i d
scraping or damaging them.
CAUTION
Upon disassembly and reassembly,
check the position of inner cover (2)
and make sure that it is properly seated
on the front fairing.
1 2
1
Working on the rear left side of the front
◆
fairing, adjust the appropriate screw (3)
b y m e a n s o f a s h o r t c r o s s - t i p
screwdriver.
By SCREWING IT (clockwise), you set
the beam upwards.
By UNSCREWING IT (anticlockwise),
you set the beam downwards.
3