Fitting The Crankcase - APRILIA Quasar 50 Manual

QUASAR 50-100
3.8.5

FITTING THE CRANKCASE

Apply grease to the oil seals and oil to the bearings so as to protect the
crankshaft (1) against possible scoring and facilitate the fitting.
Using an automatic heater, heat the right-hand crankcase to approximately
150 °C (~ 10 minutes' operation).
Install the crankshaft (1) into the left-hand crankcase (2).
Mount the right-hand crankcase on the crankshaft.
Tighten the six fastening screws (3) in a cross pattern.
Torque wrench setting for screws (3): 9 Nm
(0.9 kgm).
Fit the circlip (4).
After completing the operation, check that the crankshaft (1) has been
properly installed.
IMPORTANT
If necessary, use a mallet to restore the axial play.
Carry out this operation with a plastic or rubber mallet, not an iron
hammer. Take care not to hit the crankshaft.
Release 00/2003 - 06
1
3
ENGINE
1
2
1
3
4
3
- 31 -
00