Fuel Tap - APRILIA Quasar 50 Manual

QUASAR 50-100
Make sure that the filtering element is positioned correctly, in such a
way as to prevent non-filtered air from entering.
Remember that the untimely wear of the piston segments and the
cylinder may be caused by a faulty or uncorrectly positioned filtering
element.
Release and remove the three screws (3).
Remove the filter case cover (4).
Remove the air cleaner (5).
PARTIAL CLEANING
Do not use screwdrivers or alike.
Seize the air cleaner (5) vertically and strike it more than once on a clean
surface.
If necessary, clean the air cleaner (5) with a compressed air jet (directing it
from the inside towards the outside of the filter). If necessary, wash the air
cleaner (5) with water and pH neutral detergent.
Moisten the air cleaner (5) in mixer oil, see 1.8 (LUBRICANT CHART).
When cleaning the filtering element, make sure that it is not torn or
otherwise damaged.
Otherwise, change the filtering element.
Clean off excess oil as shown in the figure.

2.11 FUEL TAP

The fuel system is equipped with a tap which can be closed when the
motorcycle is not being used.
The fuel tap (1) is at the top of the engine.
The tap can be set to three positions:
ON
When the tap is set to ON, the fuel will flow from the tank to the carburettor.
Set the tap to this position when using the motorcycle normally.
Release 00/2003 - 06
PERIODIC MAINTENANCE
3
4
5
1
2
- 13 -
00