Adjusting The Vertical Headlight Beam; Bulbs - APRILIA SCARABEO 50 I.E-100 4T - 2001 Manual

ADJUSTING THE VERTICAL
HEADLIGHT BEAM
NOTE
To check the direction of the head-
light beam, specific procedures must be
adopted, in accordance with the regulations
in force in the country where the vehicle is
used.
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10 m
away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
To adjust the headlight beam:
Position the vehicle on the centre stand,
on a solid and level surface.
Act on the suitable screw (1) by means of
a screwdriver.
By TURNING IT CLOCKWISE, you set the
beam upwards.
By TURNING IT ANTICLOCKWISE, you
set the beam downwards.

BULBS

Carefully read pages 48-53 (REGULAR
SERVICE INTERVALS CHART).
Risk of fire.
Keep fuel and other flammable sub-
stances away from the electrical compo-
nents.
1
Before changing a bulb, position the ve-
hicle on the centre stand, move the igni-
tion switch to position "
few minutes, so that the bulb cools down.
Change the bulb wearing clean gloves or
using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to avoid any damage.
DO NOT FORCE THE ELECTRIC CABLES.
use and maintenance Scarabeo 50
WARNING
CAUTION
" and wait a
- Scarabeo 100 4T 77