Removing The Engine From The Frame - APRILIA Quasar 50 Manual

ENGINE
2
3
4
3
- 4 -
00
3.1.2
Read carefully 1.3 (GENERAL SAFETY RULES).
Switch off the engine and wait for the engine and exhaust system to cool
down.
Remove both fairings, see 6.1.4 (REMOVING THE FRONT FAIRING) and
see 6.1.5 (REMOVING THE REAR FAIRING).
Remove both footpegs, see 6.1.6 (REMOVING THE FOOTPEGS).
1
To clean the outer parts of the engine use a degreaser, brushes and
wipers.
Ensure that no rubber or plastic parts come in contact with detergents
and corrosive or penetrating solvents.
Should you need a steam cleaner, do not direct water, steam or high-
pressure air jets towards any of the following parts: wheel hubs,
handlebar controls, main warning lights, exhaust silencer, main switch.
Remove the oil tank see 6.1.13 (REMOVING THE MIXER OIL TANK).
Remove the tank see 6.1.12 (REMOVING THE FUEL TANK).
Remove the exhaust system, see 6.1.25 (REMOVING THE EXHAUST).
Remove the airbox, see 2.10 (AIR CLEANER).
Disconnect the throttle cable (1) from the oil pump and remove the fan
guards, see 6.1.8 (REMOVING THE FAN GUARD).
Mark cables, hoses and pipes to avoid confusing them when refitting.
Disconnect the starter motor connector (2).
Disconnect the alternator connectors (3).
Disconnect the spark plug cap (4).
Disconnect the fuel pipe (5).
Unscrew and remove the two screws (6).
Extract the throttle cable from the carburettor making sure not to damage
the needle.
5
6

REMOVING THE ENGINE FROM THE FRAME

QUASAR 50-100
Release 00/2003 - 06