Adjusting The Vertical Headlight Beam; Bulbs - APRILIA SR 50 - 2003 Manual

ADJUSTING THE VERTICAL
HEADLIGHT BEAM
NOTE
To check the direction of the
headlight beam, specific procedures must
be adopted, in accordance with the
regulations in force in the country where the
vehicle is used.
NOTE
For the versions equipped with low/
high beam , it is not necessary to remove
the front cover.
◆ Remove the front cover, see p. 49
(REMOVING THE FRONT COVER).
◆ Act on the suitable screw (1) by means of
a screwdriver.
1
◆ Act on the suitable screw (2) by means of
a screwdriver (for the countries where
required).
By TURNING IT CLOCKWISE, you set the
beam downwards.
By TURNING IT ANTICLOCKWISE, you
set the beam upwards.

BULBS

Carefully read p. 44 (MAINTENANCE).
WARNING
Risk of fire.
Keep fuel and other flammable substances
away from the electrical components.
2
CAUTION
Before changing a bulb, position the vehicle
on the centre stand, move the ignition
switch to position " " and wait a few
minutes, so that the bulb cools down.
Change the bulb wearing clean gloves or
using a clean and dry cloth.
Do not leave fingerprints on the bulb, since
these may cause its overheating and
consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to avoid any damage.
DO NOT FORCE THE ELECTRIC WIRES.
use and maintenance SR 50
71