ENGINE
QUASAR 50-100
3.6.2
REFITTING THE STARTING SYSTEM
Refit, in the following order, the return spring (1), the pedal shaft (2), the bush,
the plain washer and the circlip (3).
Attach the return spring (1) to the pedal spindle (2) and, using a spring pull
hook, fix the other end to the pin.
IMPORTANT
When hooking the spring (1), avoid pulling it too hard.
Excessive pulling may cause the spring to yield.
1
2
This is a dangerous operation.
Fit, in the following order, the pinion gear (4) and the spring. Slightly shift the
pedal shaft (2) to facilitate the insertion of the gear.
IMPORTANT
Lubricate the spring and the sector gear with recommended
grease, see 1.8 (LUBRICANT CHART).
3
4
3
- 18 -
00
Release 00/2003 - 06