Connecting Signal Cables; Inputting Image From Main To Sub; Inputting Image To Sub And Main Individually - Christie DWU951 User Manual

4.2 Connecting signal cables

There are two methods to input image to the Sub projector. ( 17 )
- Inputting image from the MONITOR OUT port on Main to Sub.

- Inputting image to Sub and Main individually.

Inputting image from Main to Sub

1.
Connect the MONITOR OUT port on Main
to the COMPUTER IN1* port on Sub with a
computer cable.
2.
Connect the image output device to one of
the input ports on Main.
NOTES for Intellectual Stack
• COMPUTER IN1* and IN2* can be used
as the input port for the Main projector in
Intellectual Stack. Do not use other ports for
image input.
- You can input component signals to
COMPUTER IN1* and IN2*.
- You can input video signals to the Y pin of
the component video of COMPUTER IN1* and
IN2*.
NOTES for Simple Stack
• COMPUTER IN1* and IN2* can be used
as the input port for the projector that is
connected with a computer cable at its
MONITOR OUT port. (Operating Guide
→ SETUP menu) If you wish to use other
input ports, input the image to Sub and Main
individually.
*) For DHD951, COMPUTER IN
Inputting image to Sub and Main individually
1.
Split the output signal from your image device into two with device such as a
signal splitter.
2.
Connect the output ports of the image output device to the same input ports on
the Main and Sub projectors.
NOTES for Intellectual Stack • LAN cannot be used as the input port
on the Main projector in Intellectual Stack.
NOTES for Simple Stack • Any of the ports that is compatible with the
signal can be used. Input the same signal to the two projectors individually.
DWU951/DHD951/DWX951/DXG1051 User's Manual - Instant Stack Guide
DWU951/DWX951/DXG1051
23
Connecting cables
Main
DHD951
Sub
Example of connection
for Intellectual Stack
020-000663-02 Rev. 1 (06-2014)
Sub
Main