Installing The Second Projector (Set B); Deciding On The Installation Position; Connecting Projectors; Setting Up Set B - Christie DWU1052 User Manual

Installation

2.3 Installing the second projector (Set B)

Deciding on the installation position

Decide on the position of Set B and its projection angle.
→
(concise) Arrangement
WARNING ►You can install the projector for any direction with specified
mounting accessories. Consult with your dealer about this installation.
• Set the tilt angle of Set B to within 5 degrees from the level line.
NOTE

Connecting projectors

To use Intellectual Stack, connect an RS-232C cross cable between the CONTROL
port of Set A and Set B.

Setting up Set B

1.
Turn on Set B.
• After turning on Set B, make sure the image of Set B is not
NOTE
significantly tilted compared to the image of Set A. If the image is overly tilted,
rotate the elevator feet of Set B to adjust the angle such that the tilt is just
about right.
2.
Reset the adjustment of KEYSTONE and 3D KEYSTONE on Set B.
(Operating Guide
• KEYSTONE, 3D KEYSTONE, and WARPING functions cannot be
NOTE
used at the same time. Use an appropriate function.
•Run the INSTALLATION setting first if necessary as it may change the image
(Operating Guide
position.
(continued on next page)
DWU1052/DHD1052
User's Manual - Instant Stack Guide
and Adjusting the projector's
→
EASY MENU or
→
SETUP
8
(User's Manual
elevator)
SETUP menu)
menu)
020-000856-01 Rev.1 (12-2015)
LIT MAN USR DWU/DHD1052 ISG