Installing The Second Projector (Set B); Deciding Installation Position; Connecting Projectors; Setting Up Set B - Christie LX501 User Manual

LX501/LX601i/LW401/LW551i/LWU421/LWU501i
Installation

2.3 Installing the second projector (Set B)

Deciding installation position

Decide the position of Set B and its projection angle.
→ Arrangement and
WARNING ►Only for LX601i, LW551i and LWU501i, it is possible to install
the projector for any direction with specified mounting accessories. Consult with
your dealer about such a special installation.
• Set the tilt angle of Set B to within 9 degrees from the level line.
NOTE

Connecting projectors

To use Intellectual Stack, connect an RS-232C cross cable between the
CONTROL port of Set A and Set B.

Setting up Set B

1.
Turn on Set B.
• After turning on Set B, make sure the image of Set B is not
NOTE
significantly tilted compared to the image of Set A. If the image is overly
tilted, rotate the elevator feet of Set B to adjust the angle such that the tilt is
just about right.
2.
Reset the adjustment of KEYSTONE and PERFECT FIT on Set B.
(Operating Guide
• KEYSTONE cannot be operated when PERFECT FIT is in use. To
NOTE
reset both functions, reset PERFECT FIT first.
• Perform the INSTALLATION setting first if necessary as it may change the
image position.
(continued on next page)
Instant Stack Guide
Adjusting the projector's
→ EASY MENU
(Operating Guide
(User's Manual (concise)
elevator)
or SETUP menu)
→ SETUP menu)
8
020-000489-02 Rev. 1 (06-2012)