Table of Contents
Advertisement
Step 6: Handle Bar Assembly
A. Place bike upright on all four feet.
B.
Align the Handlebar Assembly(7) with the Handlebar Bracket(H) on the
Console Mast(6).
C
Feed the wire harness connector from the top of the Console Mast(6)
through the square hole in the middle of the Handlebar Assembly(7).
There should be three wire connectors coming out the top of the handlebar
assembly.
D. Place the Handlebar Assembly(7) into the Handlebar Bracket(H) and align with
bolt holes. Be sure to pull any slack wiring through the handlebar assembly
so the wire harness does not get pinched.
E.
Install two M8 Bolts(20) through the Handlebar Assembly(7) into the
Handlebar Bracket(H).
F.
Securely tighten bolts.
H
6
20
7
Assembly
5mm Allen
Wrench w/
Phillips
13
Advertisement
Table of Contents
