Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Hydraulic Installation
NOTES
See Figures 3-9
or
3-12
(factory installed and those installed during setup.)
1. Attach the base end of each 4-1/2 x 30 hydraulic
cylinder to the fold cylinder mount on the center
frame with clevis and roll pins provided with each
cylinder as shown in
cylinders so the hydraulic ports point to rear on front
cylinders and to front on the rear cylinders.
CLEVIS & ROLL PINS
PROVIDED W/CYLINDER
Figure 3-6: Fold Cylinder Installation
NOTE
Rod ends of fold cylinders need to be left
unassembled until fold hydraulic system is fully
charged with oil to prevent machine damage.
2. Using 1-1/4 x 6-1/8 fold pin, 1-1/4N flat washers, and
5/16 x 2-1/2 spring slotted pins, attach the rod end of
the 4-1/2 x 30 cylinders to the slotted mounts on the
wing frames
See Figures
Restrictors are installed in the rod end of wing
fold cylinders to prevent uncontrolled dropping
of wings. Removal of these restrictors, or
improper installation can result in serious
damage to the implement.
proper restrictor fitting identification and
location.
3. Install 90 degree regular adapter fittings in both ends
of all lift cylinders (4 x 10 and 3-3/4 x 10)
Figures
3-9. Base fittings point downward, rod
fittings point upward.
3-12
for hydraulic cylinder fittings
See Figures
3-6. Position the
4-1/2 X 30 CYLINDER
FOLD & ROLL PINS,
1-1/4N FLAT WASHERS
3-6.
CAUTION
See Figures 3-12
See
4. Install a 6-1/4" long piece of black trim in the top hole
of the lift bearing caps. Outer wing bearing caps do
not require trim. Route rear fold and lift hydraulic
hoses through bearing caps between frame sections
See Figure
5. Install lift system hoses per Figure 3-9. Wrap lift
system hoses with blue hose wrap.
6. Install fold system hoses per Figure 3-12. Wrap fold
system hoses with yellow hose wrap.
7. Attach hose clamps to the center and wing frames
See Figures 3-8
screws and 3/4 lock nuts.
Figure 3-8: Hose Clamp Installation
for
3-7.
6-1/4" LONG BLACK TRIM
LIFT BEARING CAP
Figure 3-7: Trim Installation
using 3/8 x 2-3/4 hex head cap
3/8 X 2-3/4 BOLT,
3/8 LOCK NUT
F-1105-1120
Advertisement
Table of Contents
