HAKO Citymaster 650 Operating Manual page 86

Operation
Fig. 87:
Fig. 88:
Fig. 89:
86
Activating work mode
Use the Hako button Fig. 87-71 to change over from transport mode to
work mode.
The accelerator pedals must be in the neutral position.
71
The work mode with front tool carrier information symbol Fig. 87-A
appears in the multifunction display.
The driving speed in the work mode is 0 to 25 km/h.
A
Setting engine fixed speed for attachments/options
A
The engine speed for attachments or options is set with the switch
Fig. 88-A. Set the speed according to the requirements.
Stage
1 – ECO
2 – Standard
3 – Maximum 2630
Activating the front tool carrier
The front tool carrier is activated with the joystick Fig. 89-70. The following
70
functions are possible for a vehicle without attachment:
•
Raising front tool carrier
•
Lowering front tool carrier (floating position)
The function of the joystick with an attachment is described in chapter 6.
Raising the front tool carrier is interrupted if the driver leaves the driver's
seat.
rpm Front attachment: l/min Rear attachment: l/min
1900 25
2250 29
35
19
22
27
03-147015-00-00.fm