Check-List - Cleaning The Vacuum Sweeping System - HAKO Citymaster 650 Operating Manual

Check-list – Cleaning the vacuum sweeping system
No. Description
1 Emptying the dirt hopper
2
Cleaning the sweeping unit
3
Cleaning the dirt hopper and circulating water system
4
Emptying the fresh water tank
5
Emptying the circulating water tank
Caution
•
Do not exceed the permissible total weight. There is a risk of accidents!
•
Frequently check the filling level of the dirt hopper. Switch the suction fan off for this! The lid of the
dirt hopper must not be opened when the suction fan is running. There is a risk of injury!
•
Do not use steam cleaners and high-pressure cleaners for cleaning electrical/electronic compo-
nents and the engine compartment!
Note
•
The cleaning work listed below must be done after every emptying, at least once daily.
Emptying the dirt hopper
1. Lock the sweeping unit, start the vehicle with the ignition switch and
drive to a suitable cleaning place.
2. Reverse carefully to the offloading place and engage the parking brake.
Switch the suction fan off!
3. Before emptying the dirt hopper Fig. 148-85 open the lock Fig. 148-A
of the lid.
• Pull the handle out from the lock to open.
• Push the handle into the lock to close.
4. Raise and empty the dirt hopper with the button Fig. 148-74.
5. Lower the dirt hopper and lock the lid again.
06-147015-00-00.fm
Attachments and Options
74
85
A
Fig. 148:
Reference
Page 143
Page 144
Page 145
Page 145
Page 145
143