HAKO Citymaster 650 Operating Manual page 120

Maintenance and Servicing
(-)
Fig. 114:
120
Starting with jumper cables
1. Place the vehicle on a level surface and hold it with the parking brake.
(+)
Switch the engine off and pull out the ignition key. Let the engine cool
down.
2. Switch engine and electrical consumers of both vehicles off.
3. Open the right side panelling, see page 102.
4. Connect the plus cable (red) with one end to the plus pole (+) of the
empty battery and with the other end to the plus pole (+) of the assisting
vehicle.
5. Connect the minus cable (black) to the minus pole (-) of the supporting
vehicle and to the minus pole (-) of the Citymaster 650.
6. Start the engine of the assisting vehicle.
7. Start the Citymaster 650.
8. When removing the jumper cable, first remove the minus poles (-) and
then the plus poles (+).
05-147015-00-00.fm