HAKO Citymaster 650 Operating Manual page 168

Attachments and Options
Fig. 180:
37
Fig. 181:
A C
Fig. 182:
168
Setting the fixed engine speed
The fixed engine speed is set with the switch Fig. 180-64. Set the speed
according to the requirements.
The speed must be set so that a centrifuging effect is achieved.
Stage
1 – ECO
2 – Standard
64
3 – Maximum 2630
Starting sweeping
36
The accelerator pedal Fig. 181-36 is used for continuously changing the
speed for driving forwards.
The accelerator pedal Fig. 181-37 is used for continuously changing the
speed for reversing.
Push the accelerator pedal down slowly until the vehicle starts, the speed
is increased further by pressing on the pedal.
Slowing down or braking the vehicle: Slowly reduce the pressure on the
accelerator pedal, the vehicle slows down or stops.
The vehicle speed in the:
•
transport mode is 0 to 25 km/h,
•
work mode 15/20/25 km/h according to selected engine speed.
Setting down the front sweeping machine
B
Set the front sweeping machine so that the bristles of the sweeping roller
do not touch the ground.
1. Loosen the support Fig. 182-A from the rear holder Fig. 182-B of the
front sweeping machine by removing the bolt and split-pin.
2. Insert the support in the front holder Fig. 182-C.
3. Secure with bolt and split pin when the required supporting height is
reached.
rpm Use
1900 At low load
2250 For medium load
For high load
06-147015-00-00.fm