Changing Mowing Blades; Changing The V-Belt; Cleaning The Mower; Cleaning The Suction Nozzle - HAKO Citymaster 650 Operating Manual

Changing mowing blades

1. Place the vehicle on a level surface and hold it with the parking brake.
Raise the mower with the joystick Fig. 172-70. Switch the engine off
and pull out the ignition key.
2. Loosen the screw Fig. 172-A and take off the disk and mowing blade.
3. Fit new mowing blade with disk and screw.
Note
Tightening torque of the mowing blades: 120 Nm

Changing the V-belt

1. Place the vehicle on a level surface and hold it with the parking brake.
Raise the mower with the joystick Fig. 172-70. Switch the engine off
and pull out the ignition key.
2. Loosen the screws on the covers Fig. 172-B and remove the covers.
3. Relax the tension spring with the screw Fig. 172-C and unhook it.
4. Remove the screws of the gearbox holder Fig. 172-D and remove the
defective V-belt.
5. Insert the new V-belt corresponding to Fig. 172-X.
6. Fasten the screws on the gearbox holder.
7. Adjust the clamping screw again corresponding to the clamping length
of the label (165 mm).
8. Refit the covers correctly.

Cleaning the mower

1. Place the vehicle on a level surface and hold it with the parking brake.
Raise the mower with the joystick Fig. 172-70. Switch the engine off
and pull out the ignition key.
2. Bring the mower into the cleaning position with the mounting bolt
Fig. 172-E.
3. Clean the mower from the outside with a water hose or a high-pressure
cleaner.
4. Plug the water hose onto the three hose couplings Fig. 172-F one after
the other and clean with a water hose. Let the mower run for one to two
minutes for this.

Cleaning the suction nozzle

1. Place the vehicle on a level surface and hold it with the parking brake.
Raise the mower with the joystick Fig. 172-70. Switch the engine off
and pull out the ignition key.
2. Turn the steering wheel as far as possible to the right.
3. Open the flap Fig. 172-I with the lance Fig. 172-H. Let the suction fan
run for one to two minutes.
4. Lock the flap again with the lance.

Lubrication points

Check the lubrication points weekly.
Grease: Mobilgrease MP
•
Bushes of the wheel holders Fig. 172-G (4 pieces)
06-147015-00-00.fm
Attachments and Options
161