HAKO Citymaster 650 Operating Manual page 74

Use
X1
X3
Fig. 64:
F
Fig. 65:
74
Securing the front tools
1. Bring the locking hook into the front position and the lever into the lower
X2
position (I).
2. The movement limiter of the front tool carrier is determined by the
chain Fig. 65-C and the hooking point of the chain.
• For vacuum sweeping, hook the chain in the holder Fig. 65-D with the
first link.
• For attachments with floating position the chain must be hooked onto
the hook Fig. 65-E!
X4
3. Check the locking plate Fig. 65-F on the attachment. If necessary,
loosen the screws and shift the locking plate.
The following is shown in the multifunction display: Driver not on driver's
seat Fig. 64-X1; upper end position of the front tool carrier Fig. 64-X2;
floating position of the front tool carrier Fig. 64-X3; front tool carrier low-
ered and fixed Fig. 64-X4.
A B
C 12
I II
B
E C
02-147015-00-00.fm
D