Motorola MVME147 Installation And Use Manual page 167

Terminal Input/Output Control
When entering a command at the prompt, the following control
codes may be entered for limited command line editing.
Note
^X (cancel line)
^H (backspace)
^D (redisplay)
Delete (delete)
key
When observing output from any 147Bug command, the XON and
XOFF characters which are in effect for the terminal port may be
entered to control the output, if the XON/XOFF protocol is enabled
(default). These characters are initialized to ^S and ^Q respectively
by 147Bug, but you may change them with the PF command. In the
initialized (default) mode, operation is as follows:
^S
^Q
The presence of the caret ( ^ ) before a character
indicates that the Control (
down while striking the character key
The cursor is backspaced to the beginning of the line. If
the terminal port is conÞgured with the hardcopy or
TTY option (refer to the PF command), then a carriage
return and line feed is issued along with another
prompt.
The cursor is moved back one position. The character at
the new cursor position is erased. If the hardcopy
option is selected, a Ò/Ó character is typed along with
the deleted character.
The entire command line as entered so far is
redisplayed on the following line.
Performs the same function as ^H.
(wait) Console output is halted.
(resume) Console output is resumed.
Terminal Input/Output Control
) key must be held
CTRL
.
B
B-13