Punch Unit - Sharp AR-FN8 Service Manual

CHAPTER 8 UNPACKING AND INSTALLATION
II. PUNCH UNIT
When installing a hole punch unit in a finisher AR-
FN 8/9,follow these install instructions instead of pro-
cedures 19-b to 19-f in the install instructions for the
AR-FN 8/9.
WARNING
The unpacking and set-up procedure shall
be done by a qualified service technician.
1)Unplug
2)Un pack the punch unit and the accessories
4
17
11
3)Unpack the screws
9
8-6
19
12
3
21
7
12
15
4)Remove the lock screws
5)Remove the mylar sheet
If you are installing a hole punch unit on the AR-FN
8/9, then you must first remove the mylar sheet lo-
cated on the finisher entrance
6)Remove the cover
7)Install the screws