Sharp AR-FN8 Service Manual page 183

6) Remove the stitcher positioning tool [3]
from the back of the cover.
7) If you must adjust the front stitcher, remove
the center guide plate [5] and front guide
plate [4] (one screw each). If you must ad-
just the rear stitcher, remove the center
guide plate [5] and the rear guide plate [6]
(one screw each).
8) If you must adjust the front stitcher, loosen
the two screws [8] on the stitcher mount
[7]. If you must adjust the rear stitcher,
loosen the two screws [9].
CHAPTER 5 MECHANICAL CONSTRUCTION
[3]
Figure 5-227
[6] [5]
Figure 5-228
[9]
[7]
Figure 5-229
[4]
[8]
5-29