Removing The Positioning Plate Unit - Sharp AR-FN8 Service Manual

CHAPTER 5 MECHANICAL CONSTRUCTION
9) Insert the tool [10] into the staple slot of
the stitcher [9].
10) Shift down the stitcher and turn the stitcher
gear so that the boss on the tool [11] and
the recess of the mount match. Then tighten
the screws [12] on the mount to fix the two
in place.
6. Removing the Positioning Plate
Unit
1) Remove the saddle stitcher controller PCB.
(See II-C-1.)
2) Disconnect the two connectors [1], take out
the three harness stops [2], and remove the
harness leads [3] from the two edge saddles
[4].
3) Take out the two screws [5], slide the posi-
tioning plate unit [6] once towards the front
and remove from the rear side.
5-30
[10]
Figure 5-230
[11]
[12]
Figure 5-231
[2]
Figure 5-232
[9]
[3]
[6]
[1]
[5] [4]