Removing The Scrap-Full Detector Pcb Unit; Removing The Punch Driver Pcb - Sharp AR-FN8 Service Manual

CHAPTER 5 MECHANICAL CONSTRUCTION
3. Removing the Scrap-Full Detector
PCB Unit
1) Remove the right guide assembly. (See III-
A-1.)
2) Remove the screw [1], disconnect the con-
nector [2], and take out the scrap-full de-
tector PCB unit [3].
4.

Removing the Punch Driver PCB

1) Remove the puncher unit from the finisher.
2) Remove the four screws [1], disconnect six
connectors [2], and take out the punch
driver PCB [3].
5-40
[1]
Figure 5-314
[3]
[1]
[2]
[1]
[2]
Figure 5-315
[3]
[2]
[1]
[2]
[1]