Removing The Horizontal Registration Motor; Removing The Punch Unit - Sharp AR-FN8 Service Manual

2. Removing the Horizontal
Registration Motor
1) Remove the right guide assembly. (See III-
A-1.)
2) Disconnect the connector [1].
3) Remove the two screws [2] and slide the
horizontal registration motor [3] in the di-
rection of the arrow.
3.

Removing the Punch Unit

1) Remove the right guide assembly. (See III-
A-1.)
2) Remove the three connectors [3].
3) Remove the wire harness [3] from the three
wire-harness clamps [2].
4) Remove the wire-harness band [3a].
CHAPTER 5 MECHANICAL CONSTRUCTION
Figure 5-305
[2]
[3a]
Figure 5-306
[2]
[3]
[1]
[1]
[1]
[3a]
[2]
[3]
5-35