Table of Contents
Advertisement
9) Change the settings of bits 6 through 8 of
DIP_SW1 to match distance L referring to
the table below.
• If the width adjustment is "0"
The stitching position and the folding po-
sition match, requiring no change.
• In the case of "positive width adjustment"
Set DIP_SW1 so that the difference ob-
tained by subtracting the interval from the
appropriate setting is provided.
Example) If DIP_SW1 is currently set to
2 and the interval is 1 mm, set
DIP_SW1 to "0".
• In the case of "negative width adjustment"
Set DIP_SW1 so that the sum obtained by
adding the interval from the appropriate
setting is provided.
Example) If DIP_SW1 is currently set to -
1 and the interval is -1.0 mm, set
DIP_SW1 to " 1".
DIPSW1 bit settings
bit 6
bit 7
bit 8
OFF
ON
ON
OFF
ON
OFF
OFF
OFF
ON
OFF
OFF
OFF
ON
OFF
ON
ON
ON
OFF
ON
ON
ON
Do not change the following bit settings
bit 6
bit 7
bit 8
ON
OFF
OFF
Table 7-101
10) Set bits 1 through 4 of DIP_SW1 to OFF.
2.
Stitching Position (adjusting cen-
ter stitching)
Use the host machine user mode to per-
form the following.
For details of adjustment methods, refer to
the Operator's Manual for the host machine.
Settings
(in units of 0.25 mm)
3 ( 1.5mm)
2 ( 1.0mm)
1 ( 0.5mm)
0
−1 (−0.5mm)
−2 (−1.0mm)
−3 (−1.5mm)
CHAPTER 7 TROUBLESHOOTING
C.
Electrical System (puncher
unit (option))
1.
Sensor output adjustment
Perform this adjustment when the punch
driver PCB, transmission sensor (photosensor
PCB LED PCB) or reflection sensor (scrap-full
detection PCB unit) has been replaced.
1) Remove the rear cover of the finisher unit.
2) Set bits 1 through 6 of DIPSW3 on the fin-
isher controller PCB as indicated.
Figure 7-109
3) Press SW1 on the finisher controller PCB.
Pressing this switch automatically adjusts
sensor output.
4) Set all bits on DIPSW3 to OFF.
2.
Registering the number of punch
holes
This operation registers which puncher unit
is attached to the IC on the punch driver PCB
so that the puncher unit can be identified by
the finisher. For this reason, this operation must
be performed when the punch driver PCB has
been replaced.
1) Remove the rear cover of the finisher unit.
2) Set bits 1 through 6 of DIPSW3 on the fin-
isher controller PCB as indicated.
Figure 7-110
5
6
7
8
5
6
7
8
7-5
Advertisement
Table of Contents
Troubleshooting
